Hunter Pro-C Controller Product Information page 22

PROGRAMMING
Run
After programming is complete,
turn the dial to RUN to enable
automatic execution of all
selected programs and start times.
Watering will not occur unless
dial is in the RUN position.
System Off
Valves currently
SYSTEM OFF
watering will be shut off
after the dial is turned
to the SYSTEM OFF
position for two seconds.
All active programs are discontinued and
watering is stopped. To return controller to
normal automatic operation, simply return dial
to RUN position.
Manually Run a Single Station
1. Turn the dial to the MANUAL-
SINGLE STATION
position.
2. Station run time
MANUAL – SINGLE STATION
will flash in
the display. Use
the button to move
to the desired station.
You may then use the
and buttons to
select the amount of
time for a station to water.
3. Turn the dial to the RUN position to run
the station (only the designated station will
water, then controller will return to auto-
matic mode with no change in the previ-
ously set program).
Manually Run All Stations
1. Turn the dial to
MANUAL – ALL STATIONS
MANUAL-ALL
STATIONS.
2. You can select program
A, B, or C by pressing
the button.
20
(continued)
RUN
3. Press the
station is displayed.
4. Station run time will flash in the
display. Use the
to select the amount of run time
for the station to water if different
from the run time displayed.
5. Use the
next station.
6. Repeat steps 3 and 4 to customize
each station if desired.
7. Press the
station is displayed.
8. Return the dial to RUN (custom program
will water the entire program beginning
with the station number last left in the
display, then controller will return to
automatic mode with no change in the
previously set program).
One Touch Manual Start and Advance
You can also activate all stations to water
without using the dial.
1. Hold down the
2. This feature automatically defaults to
program A. You can select program B, or C
by pressing the
3. The station number will be flashing.
Press the
the stations and use the
adjust the station run times. (If no buttons
are pressed during step 2 or 3, the control-
ler will automatically begin program A.)
4. Press the
you wish to begin with. After a 2 second
pause, the program will begin.
This feature is great for a quick cycle
when extra watering is needed or if you would
like to scroll through the stations to inspect
your system.
button until desired starting
and buttons
button to move to the
button until desired starting
NOTE: The station that is on the display when
you turn the dial to RUN, will be the first station
to run. The controller will then proceed to water
in sequential order only. It will not water previous
stations.
button for 2 seconds.
button.
or button to scroll through
and
button to scroll to the station
buttons to