1.2 PHYSICAL DESCRIPTION Read the following information to familiarize yourself with the video Decoder, and make particular notes of where the connectors and LEDs are located . Action LED Indicator The LED will light up after IP device has successfully completed the boot process.
Page 4
Ground Pin Digital Input 1 Digital Input 2 Ground Pin Terminal Blocks Pin 7~12 Pin 7~10: RS232/422/485. Default mode is RS-485 Pin 11~12: DC 12V power input DESCRIPTION NAME RS-485 RS-422 RS-232 Power Input (DC +12V) Ground Pin of Power Input & RS-232 Ethernet Port The IP device connects to the Ethernet via a standard RJ45 connector.
Page 5
Audio Input / Output The IP device supports one audio input and output with earphone jack Y/C Output Analog Video Output of Y/C Signal with S-Video Connector 10. Composite Output Analog Video Output of Composite Signal with BNC Connector...
Page 6
1.3 CONNECT NECESSARY CABLES Follow the procedures below to connect the video Decoder to the respective apparatuses. 1. The IP camera or other encoding devices as a video source 2. The video server or other encoding devices as a video source 3.
Quick Tour This section guides you with a quick tour on our video Decoder 2.1 Configure the video Decoder 2.1.1 Make sure network environmen Default IP of video Decoder is 192.168.0.200. Please make sure the video Decoder and your PC are on the same network segment before running the installation.
Page 8
2.1.2 Open Internet Explorer with IP address This section describes how to configure the video Decoder. The product administrator has unlimited access to all setup windows and normal users can only watch the live images. The video Decoder is configured under a standard browser (Microsoft Internet Explorer 6.0 or above). Follow the procedures below to configure the video Decoder STEP1: Open a browser STEP2: Enter the IP address of the video Decoder.
Page 9
2.1.3 Set a new IP address *IP Address : The IP address of the LAN interface. The default IP address is 192.168.0.200. *Subnet Mask : The subnet mask of the LAN interface.The default subnet mask is 255.255.255.0 *Click button...
Page 10
2.1.4 Select a video server / IP camera This section tells you how to setup video server or IP camera’s video and streaming settings. *Source Type : Select your video source is Video Server or Quad Server. *Connect Type : Select Multicast or TCP mode for connecting to a video server/IP camera. *Variable FPS : Select variable FPS.
Page 11
2.1.5 Click Save Reboot to restore all settings and please wait about 30 seconds for system reboot.
Need help?
Do you have a question about the ACD-3100 and is the answer not in the manual?
Questions and answers