Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for ACTi ACD-2100T
Summary of Contents for ACTi ACD-2100T
- Page 1 1-channel MPEG-4 Video Encoder ACD-2100T Ver. 070206+ Quick Installation Guide...
-
Page 3: Getting Started
Getting Started PACKAGE CONTENTS ACD-2100T Power Adaptor (Option) Product CD Terminal Blocks & Screws Warranty Card... -
Page 4: Physical Description
PHYSICAL DESCRIPTION Video Input / Output The 1-channel MPEG-4 Video Encoder supports one analog video input and output of composite signal with BNC connectors Audio Input / Output The 1-channel MPEG-4 Video Encoder supports one audio input and output with earphone jack Dip Switch for Serial Port RS-485 or RS-422 pin define (default is RS-485) RS-232 pin define... - Page 5 Step 1: Switch off Video Encoderby disconnecting the power cable Step 2: Using a suitable pointed object, press and continue to hold the Reset Button depressed. While continuing to hold the reset button depressed, reconnect the power cable. Step 3: Keep holding the reset button depressed around 6 seconds, release the reset button.
- Page 6 Power Input (DC +12V) Ground Pin of Power Input & RS-232 Ethernet Port The Video Encoder connects to the Ethernet via a standard RJ45 connector. Supporting NWAY, this Video Encoder can auto detect the speed of local network segment (10Base-T/100Base-TX Ethernet).
-
Page 7: Basic Connections
BASIC CONNECTIONS Follow the procedures below to connect the Video Encoder to the respective apparatuses. 1. Connect an analog monitor to video out (BNC connector). Video Encoder 2. Connect the power adaptor to Video Encoder 3. Connect ’s ethernet port to an Ethernet (RJ45 connectors). If Video Encoder your has PoE built-in, you can regard it as a PD and connect... - Page 8 NOTE: You may find a support package for help you getting familiar with PoE. Please visit our web site, and get the support document TS-00040.
-
Page 9: Quick Tour
Quick Tour This section guides you with a quick tour on this Video Encoder. 2.1 Configure this 1-channel MPEG-4 Video Encoder 2.1.1 Make sure network environment Default IP of this Video Encoder is 192.168.0.100. Please make sure this Video Encoder and your PC are on the same network segment before running the installation. - Page 10 2.1.2 Open Internal Explorer with IP address NOTE: If your web browser is earlier than IE6, then download IE6 is recommended. NOTE: This 1-channel MPEG-4 Video Encoder default IP address is set to 192.168.0.100 2.1.3 Login with default administrator’s account & password NOTE: Default administrator account is set to Admin, password is set to 123456, and click...
- Page 11 2.1.4 Preview the video 2.1.5 Set the new IP address...
- Page 12 *IP Address : The default IP address is 192.168.0.100. *Subnet Mask : The default subnet mask is 255.255.255.0 *Click button NOTE: In your Client PC, please make sure the setting of Network Connections Type is set to Auto Negotation, since this Video Encoder follows MII standard.
Need help?
Do you have a question about the ACD-2100T and is the answer not in the manual?
Questions and answers