Prerequisites - Dell Z9100-ON Installation Manual

Table 4. QSFP28 Port LEDs (4x25 GbE or 4x10 GbE Mode)
LED
Link LED
Activity LED
Table 5. SFP+ Port LEDs
LED
Link LED
Activity LED
Table 6. Stacking Port LEDs
LED
Stacking LED

Prerequisites

The following is a list of components required for successful installation of the Z9100-ON.
NOTE: Detailed installation instructions for the Z9100-ON are provided in
Install the Z9100-ON.
• Z9100–ON chassis (or multiple chassis, if stacking)
• AC or DC cables to connect the AC or DC power source to each of the chassis' AC or DC power
supplies (country/regional specific)
• Mounting brackets for rack installation (included)
• Screws for rack installation
• #1 and #2 Phillips screw drivers (not included)
• Torx screwdriver (not included)
• Ground cable screws (included)
• Copper/fiber cables
Other optional components are:
• Ground cable
10
Description
• Off — No Link
• Solid green — Port link is 4x25 GbE
• Solid amber — Port link is 4x10 GbE
• Off — No Link
• Flashing green (~30 ms) — Port link is 4x25 GbE
• Flashing amber (~30 ms) — Port link is 4x10
GbE
Description
• Off — No Link
• Solid green — Link operating at maximum port
speed
• Solid amber — Link operating at lower speed
• Off — No Link
• Flashing green (~30 ms) — port activity
Description
• Off — System I sthe Salve of the stack
• Solid green — System is the Master of the stack
or a standalone unit
Site Preparations and
The Z9100–ON System