Whirlpool GM8155XJQ Job Aid page 28

c) Remove the two wire connectors from
the circulation motor terminals.
Screws
Wire
Connectors
d) Remove the three circulation fan motor
mounting bracket screws and remove
the motor and bracket.
e) Remove the 7 mm nut, split washer, flat
washer, and outer fan from the circula-
tion motor shaft.
7 mm Nut On Outer Fan
f) Remove the spacer and inner fan from
the circulation motor shaft.
Spacer
Screw
Circulation
Motor
This Side
REASSEMBLY NOTE: Make sure that you
mount the circulation motor on the bracket with
the two bracket holes to the left and the motor
coil positioned up, as shown above.
5.
Inner Fan
Element Screws
& Split Washers
2-16
g) Remove the two 7 mm nuts and re-
move the circulation motor from the
bracket.
Motor Coil
7 mm Nut
2 Holes
To remove the convection element:
a) If not already done, remove the rear
convection cover (see steps 3a & 3b on
page 2-15).
b) Remove the two screws and split wash-
ers from the ends of the element and
remove the two wire connectors.
c) Remove the mounting screw from the
element bracket.
d) If not already done, remove the con-
vection mounting cover from the back
of the unit (see step 4b on page 2-15).
Bracket
7 mm Nut
Bracket
Screw