Table of Contents
Advertisement
If you have difficulty getting your chartplotter to receive data from your radio, check the
chartplotter's configuration. It should be set to the following
Baud rate
Data bits
Parity
Stop bits
Data amplitude
Drive capability
NMEA Output
When the radio receives a DSC call (Distress, Position Reply, or Position Send), it outputs a
DSC/DSE sentences from the NMEA output port in the following formats:
$CDDSC,12,3081234000,,07,00,0354013946,0657,,,S,E*6D
x
$CDDSE,1,1,A,3081234000,00,60875646*13
x
ADDITIONAL FEATURES
RENAMING CHANNELS
If you discover that a marine radio channel has a different common name in your local area,
you can change the name of that channel to make it easier for you to use (see the channel
lists beginning on page E-44 for the default channel names). To rename a channel, follow
the steps below:
1.
Press MENU and select
of channels with their names.
2.
Press ▲ or ▼ to select the channel you want to change and then press RENAME.
3.
A popup keyboard displays. Enter a new name. When you have entered the name,
select FINISH.
4.
The channel list displays again with the new name.
5.
When you are satisfied with the channel list, select CLR to return to the Idle screen.
UNIDEN MARINE APP
Uniden's Marine Radio app lets you configure your MHS335BT and send text messages
from your mobile device. The app is available for iOS and Android. Go to the Apple App
store, Google Play, or Amazon to download this free app.
MAINTENANCE AND TROUBLESHOOTING
Due to its rugged design, your radio requires very little maintenance. However, it is a
precision electronic instrument, so you should follow a few precautions:
If the antenna has been damaged, do not transmit except in an emergency situation.
x
Doing so may cause further radio damage.
E-40
4800 bps
8
None
1
Over 3.0 V
Over 10 mA
RADIO SETUP
Uniden MHS335 Radio Owner's Manual
parameters:
/Channel Name. The screen displays the list
Advertisement
Table of Contents
