Installation - Panasonic FV-15NLFS1 Installation And Operating Instructions Manual

INSTALLATION

1-2 Install with the maintenance board towards side
Note
This method can not applicable for ceiling
with joists.
1. Fix the hangers (3 pcs) on fan body by screws.
(Fig.8)
2.Install hanger bolts on ceiling, and put washers
and nuts on bolts. (Hanger bolt, nut and washer
should be M8-M10 and no provided.) (Fig.9)
Unit : inch (mm)
17 1/2 (443)
3.Install the product on hanger bolts and fix the
nuts tightly. (Fig.10)
Note
Please use the spirit level to adjust the body, to
ensure that the height of the three spreaders
within ± 2 mm.
4.Install the ducts. (It is same with step 4 in P.7)
5.Set an square
inspection hole of
450 mm or more
beside and below the
maintenance board.
(Fig.11)
6.Twist hand screw open maintenance board and pull out the sub-efficient filter, fill in
beginning time on sub-efficient filter, then install back. (Refer Fig.13 ~ 15 on P.10 ~ 11)
8
4 3/8 (110)
3 1/2 (90)
1/2 (12)
Ceiling
Hanger (Fix
by 3 screws)
Hanger (Fix by
3 screws)
3-Hanger
bolts
Maintenance
board
17 3/4 (450)
Square inspection hole
Hanger (Fix by
4 screws)
Ceiling
Hanger
Unit : inch (mm)
17 3/4 (450)
Ceiling Square inspection hole
Fig.8
Nut
Washer
Nut
Fig.9
Fig.10
Fig.11