Attaching The Pedestal Bracket - Raymarine ST4000+ Owner's Handbook Manual

81131_8.book Page 66 Thursday, October 7, 2004 11:03 AM
66

Attaching the pedestal bracket

Note: If your wheel is bulkhead or box pedestal mounted, you will
need to obtain a bulkhead fitting kit (part number E15017) from your
Raymarine dealer. Fitting instructions are supplied with the kit.
Motor tube location
Depending on the design of your pedestal and any surrounding
obstructions, you can mount the wheel drive in one of two ways:
• Slot 1 installation: the standard position uses slot 1 on the back of
the wheel drive (the slot closest to the motor tube) so the motor
tube is at the bottom to the right of the pedestal
• Slot 2 installation: the alternative installation uses slot 2 to
position the motor tube at the top to the left of the pedestal
Select the appropriate slot so the motor tube is clear of obstructions.
CAUTION:
If you use slot 2 and you have a pedestal-mounted compass, the
drive motor may affect compass readings.
Slot 1
ST4000+ Wheel & Tiller Autopilots: Owner's Handbook
lot 1 installation: lot 2 installation:
motor tube at motor tube at
bottom right top left
Slot 2
5407-2