Preboot Blinking Power Button Codes - Dell Precision 5820 Owner's Manual

Tower
Hide thumbs Also See for Precision 5820:
Table of Contents

Advertisement

Preboot blinking power button codes

Table 21. Power button LED state
Power Button LED State
Off
Blinking Amber
Blinking White
Solid Amber
Solid White
Table 22. Diagnostic Indicator table
Power Light: Amber-White
Blinking
1-1
1-2
1-3
2-1
2-2
Amber/White Blinking Pattern
1 amber blink followed by a short
pause, 1 white blink, long pause,
then repeats
1 amber blink followed by a short
pause, 2 white blinks, long
pause, then repeats
1 amber blink followed by a short
pause, 3 white blinks, long
pause, then repeats
2 amber blinks followed by a
short pause, 1 white blink, long
pause, then repeats
2 amber blinks followed by a
short pause, 2 white blinks, long
pause, then repeats
Description
Power is Off. LED is blank.
Initial State of LED at power up. See the table below for Blinking
Amber pattern diagnostic suggestions and possible failures.
System is in a low power state, either S1 or S3. This does not
indicate a fault condition.
The second state of the LED at power up, indicates that the
POWER_GOOD signal is active and it is probable that the power
supply is fine.
System is in S0 state. This is the normal power states of a
functioning machine. The BIOS will turn the LED to this states to
indicate it has started fetching op-codes.
Problem Description
Faulty System board
Bad system board, Power
Supply or Power Supply cabling
Bad system board, Memory or
Processor
Bad Processor
Motherboard: BIOS ROM failure
Suggested Resolution
To troubleshoot the issue with
system board, contact Tech
support.
If you can assist to
troubleshoot, narrow down
the issue with PSU BIST
Test, reseat cable.
If nothing works, contact
Tech Support
If you can assist to
troubleshoot, narrow down
the issue by reseating
memory and swapping a
known good memory if
available.
If nothing works, contact
Tech Support
CPU configuration activity is
in progress or a CPU failure
was detected.
Contact Tech Support
System is in Recovery Mode.
Flash latest BIOS version. If
problem persists, contact
Tech Support
Troubleshooting
93

Advertisement

Table of Contents
loading

This manual is also suitable for:

Precision 5820 tower d02t

Table of Contents