Operating Range For The Remote Control - NEC MultiSync V984Q User Manual

IMAGE FLIP Button
Toggle switches between [H FLIP], [V FLIP], [180° ROTATE]
and [NONE]. See page 35.
ACTIVE PICTURE Button
Selects active picture.
MULTI PICTURE Button
ON/OFF Button: Toggle switches between ON and OFF.
MODE Button: Selects a mode from PIP (picture in picture)
or PBP (picture by picture).
CHANGE Button: Swaps images between two pictures.
PICTURE ASPECT Button: Selects active picture frame
aspect.
NOTE: Enable to change each multi picture size by pressing
SET/POINT ZOOM button during multi picture mode.
REMOTE ID Button
Activates the REMOTE ID function. See
1
MTS Button*
*1: This button's action depends on which option board you are using.
Refer to the option board's user's manual for further information.
NOTE: The buttons with no explanation do not function.
Operating Range for the Remote
Control
Point the top of the remote control toward the LCD monitor's
remote control sensor during button operation.
Use the remote control within a distance of about 7 m (23 ft.)
from the remote control sensor, or at a horizontal and
vertical angle of within 30° and within a distance of about
3.5 m (10 ft.).
page 47.
Caution: Important, the remote control
Handling the remote control
•
•
•
•
English-14
system may not function when
direct sunlight or strong
illumination strikes the
remote control sensor, or
when there is an object in
the path.
Do not expose to strong shock.
Do not allow water or other liquid to
splash on the remote control. If the
remote control gets wet, wipe it dry immediately.
Avoid exposure to heat and steam.
Except to install the batteries, do not open the remote
control.