Carpet Cleaning - Bissell STAINEXPERT 6 User Manual

Carpet Cleaning

TIP: Remove loose dirt and impediments before cleaning.
1
Plug the power cord into a
properly grounded outlet.
4
Recline the machine by pressing the
gray release switch with your foot.
5
ATTENTION: To prevent damage to Berber carpets, avoid repeated strokes in
the same area.
NOTE: You may notice hair and debris deposits on the carpet or in the tank that were
loosened by the cleaning action (especially with newer carpets that may have never been
deep cleaned before). This debris should be picked up and thrown away.
2
Set the ReadyTools Dial to
"FLOOR CLEANING".
NOTE: Do not overwet the carpet. Also
take care not to run over loose objects,
edges of area rugs, or the power cord.
NOTE: Stalling the brush by running over
loose objects, edges of area rugs, or the
power cord may cause the belts to snap
and break.
While pressing the trigger, make one slow pass
forward and back to put water and formula down.
Release the trigger and make one slow pass
forward and back over the same area to pick up
the water and formula that was just put down.
Repeat until the liquid coming up appears clean.
Continue passes without pressing the trigger until
you can't see any more water being suctioned up.
3
Turn the power on by
pressing the red Power
Switch on the back of the
machine with your foot.
www.BISSELL.com
7