3
Standalone Operation
Totalizer inputs type must be configured in terms of volumetric flow. The Data
Ranges screen provides configuration options as shown below.
1
2
3
1. Engineering Units
2. K Factor
3. Display Range
4. Zero Adjust
5. Graph Range
6. Decimal Places
3-17
Figure 3-19 Data Ranges - Digital Totalizer
Allows selection of various flow measurement units.
Enter the K factor provided on by the flow meter manufacturer.
This is the linear mapping of the input range in terms of engineering units.
This determines what will be shown in the data display area for a given
input value.
This allows for a single offset value to be entered which will be applied to
all readings in terms of the selected engineering units.
This is a subset of the display range. This determines what portion of the
full display range will be displayed initially in the waveform views. This
range can also be adjusted from the waveform view.
Select the number of decimal places for display here.
4
6
5