USB Data Logger Interface
Quick Installation Guide
Package Contents
OM-CP-IFC200
USB Interface Device
USB Cable
3.5mm Audio cable
Data Recorder Software
CD-ROM
Quick Installation Guide
OM-CP-IFC300
USB Interface Device
USB Cable
Data Recorder Software
CD-ROM
Quick Installation Guide
Software Manual
2.03.6
For XP SP3/Vista/Windows 7
OM-CP-IFC200/OM-CP-IFC300
IMPORTANT: Do not connect the interface cable to your
PC until instructed to do so or the setup will not work.
1
Set up USB Data Logger Interface
A
Insert the Omega Data Recorder
Software CD into your CD drive.
The CD should run
automatically, and the CD
Contents screen should appear.
If it does not, click the Start
button and choose Run. A dialog
box will appear, enter
D:\autorun.exe (If "D" is the
letter of your CD drive).
For Windows 7 users this
process will be a little different.
Click on the Window button in
the lower left corner of the
screen. This will bring up the
Start List. Type 'Run' in the
'Search programs and files' field.
In the next screen click on 'Run'
at the top; this will open the
Run dialog. Enter
D:\autorun.exe.
B
Click on the Install Omega
Software link on the CD
Contents screen to start the
install of the Data Logger
Software. The Install Omega
Software window will appear,
click on the Install Omega
Software link. Follow the on
screen prompts to complete the
installation. Click Back to Omega
CD Contents when completed.
See the Software Manual or go
online at
www.omega.com
for
additional information.
C
To install the drivers for the
OM-CP-IFC200/OM-CP-IFC300,
click on the Drivers and Third
Party Tools link on the CD
Contents screen. In the next
window click on Install USB
Interface Drivers. A window
will appear prompting for a
directory and to start the
installation.
The default directory is
C:\Program Files\MTI-
USB\Datalogger Interface. If
you choose to change the
location of the install directory
click on the Change Install
Location button. Once you
have the install location set
click on the Install button to
start the installation.
2
Connect the USB Data Logger Interface
A
On the OM-CP-IFC300, remove
the Warning Label to expose
Warning:
the USB connector. (The OM-CP
Install driver before
connecting this device.
-IFC200 will have an open
communication port.) Connect
one end of the USB cable to the
USB port of the OM-CP-IFC200/
OM-CP-IFC300.
B
Connect the other end to a USB
port on your PC. When the
OM-CP-IFC200/OM-CP-IFC300
is plugged in, a New
Hardware Found message will
appear in the lower right corner
of your screen. The new drivers
will automatically configure
themselves for use with the
Interface cable. A message will
then appear that the new
hardware is installed and ready
to use.
The installation of the USB data
logger interface is complete.