Omega Om-ML Series Instruction Sheet

Fl key whilst running the computer
program.
Carefully follow the instructions on the
computer screen until you get a dialogue
box saying installation complete.
' print'
command. See your MS DOS manual for
full details on how to use this command.
Included within the program is online help
which can always be viewed by pressing
the
' readme.ke file
which will have been installed onto your
hard disc.
This can be printed with the
' A:\>".
Type
"install"
and press the Enter key.
This will install the software onto the hard
disc.
Operating Instructions
To obtain the full operating instructions for
the software print off the
' A:" and press the Enter key.
This should change the prompt to
A). At the DOS
prompt type
COM4) and a
mouse.
Installation
To install the software onto your computer,
go into DOS. Insert the diskette into the
floppy disc drive (normally
KOMI, COM2, COM3 or
colour), a 3.5' disc drive, a spare serial
port
IBM' " compatible PC 286 or higher with
640kbytes RAM, a hard disk with at least
500kbytes free, a VGA screen (preferably
M277910897
You will need the OMML Series software
installed on your computer and an RS232
lead in order to use your logger. If you do
not have these, then contact your supplier.
The model and serial number of the logger
can be found on the carton and should be
quoted in any correspondence with the
supplier.
Hardware requirements
OM-ML Series
Dataloggers