Battery Pack And Power Adapter; Connecting The Battery Pack; Figure 2-25 Removing Battery Door; Figure 2-26 Connecting Battery - Omega OM-DAQXL-1 Series User Manual

2
Hardware

2.11 Battery Pack and Power Adapter

The data logger is a portable device and can operate on battery power for several
hours before requiring recharging. The included battery is a 7.2V, 4.8 Ah Li-Ion
battery. Also included is an AC adapter to provide 12VDC power for battery
recharging.

2.11.1 Connecting the battery pack

The data logger ships with the battery installed, but disconnected to keep it from
completely draining during shipment. To connect the battery pack:
1. Remove the four screws securing the battery door using the included screw
2. Remove the battery from the compartment.
3. Plug the keyed connector on the end of the battery leads into the power
4. Reinstall the battery in the compartment placing the leads under the battery.
5. Reinstall the battery compartment door and tighten the 4 battery door
2-13
driver.

Figure 2-25 Removing Battery Door.

connector in the battery compartment. IMPORTANT! Observe the correct
polarity when plugging the battery into the data logger.

Figure 2-26 Connecting Battery

Be sure not to crimp the battery leads.
screws.
Close-Up of
Battery Plug