Filter; Table Iid - Level Ii Program Values - Electronic Timeclock Filter - Autotrol Magnum Cv 942 Installation And Service Manual

6.5 Table IID
Level II Program Values - Electronic Timeclock Filter (P17=7)
Parameter Description
P1 Day of Week
and Time of day
P2 Time of day to
start regenera-
tion
P3 Factory
P4 Does not apply
P5 Factory
P6 Refill controller
P7 Brine draw rate
P9 Backwash time
P10 Does not apply
P11 Fast Rinse
P12 Units of
measure
P13 Clock mode
P14 Interval
Regeneration
P15 Does not apply
for Timeclock
operation
P16 Does not apply
for Timeclock
operation
P17 Operation type
P18 Salt Change
Lock Out
P19 Does not apply
for Timeclock
operation
P20 Does not apply
for Timeclock
operation
P21 Remote
Regeneration
Switch Delay
P22 Factory Use
Only – DO NOT
CHANGE
Min.
Range of Values
Increment
(1-7) 1:00 - 12:59 (1 day)
AM or PM 1 minute
Metric
(1-7) 0:00 - 23:59
1:00 - 12:59
AM or PM
00:00 - 23:59
2 - 200 1
2 - 200 1
7 - 60 1
7 - 125 1
9 - 60 1
0 - 1 1
0 - 1 1
0 - 30 1
0 - 1 1
1 - 254 1
Units of
Factory Value
Measure
Current Day and Hour
Time
Minute
As required Hour
Minute
10
0.5
0.2
10
200
200
14 Minutes
8 Minutes
9 Minutes
0
0
0 Days
between
regeneration
0
30
7
0
60 Seconds
99
38
Notes
Range depends on value selected for
P13
For day of week SUN=1, MON=2,
TUE=3, WED=4, THU=5, FRI=6,
SAT=7. THIS IS THE LEFT MOST
DIGIT ON THE DISPLAY
Range depends on value selected for
P13 Use only if P15 = 0 or 1
U.S.- Divide the volumetric capacity
(gallons) of the filter by 100 and enter
this number into P5
Metric - Divide the volumetric
capacity (cubic meters) by 10 and
enter this number into P5
Do not change
Do not change
May be adjusted for application
May be adjusted for application
May be adjusted for application
0 = US, 1 = Metric
0 = 12 hour clock, 1 = 24 hour clock
0 = No Interval chosen - *May be
adjusted for application
7 = Filter TimeClock
0 = none 1 = Salt /Capacity Change
Locked Out
Time remote switch must be active to
start regeneration.
Do not change