Dell Wyse 3000 Installation And Setup Manual page 8

9. Set the IP-Pool to a reasonable range
which contains your local machine's IP
address (chosen earlier). Click Next.
10. Check "Overwrite Existing File", then click
"Write INI file". Click "Next", then "Finish".
11. Open the "dhcpsrv" program as an
Administrator.
12. Check "Firewall Enabled", click
"Configure". Install the service if you have
not yet done so. Finally, click the "Start"
button to begin running the DHCP Server.
13. Open up a browser, and type in
"localhost/dhcpstatus.xml" into the
address bar. The Dell Wyse 3000 should
be detectable and listed as a client, with an
IP address assigned.
Note: If you have an instance of Apache Tomcat or any
other local server running, you should stop it before
clicking "Start" on the DHCP Server.
ThingWorx EMS Setup Guide
for the Dell WYSE 3000
Page 2-5