MicroNet SP5008A Quick Installation Manual

Network Configuration

Step 1:
Go to [ Network Configuration > WAN Setting ], and select
the right connection type (static IP, DHCP, or PPPoE) according
to your ISP or actual network.
Step 2: Press the Apply button after you finish configuration.
Step 3: Go to Reboot [ ], option and press the Reboot button.
Note:
You can retrieve the IP address of the WAN port by
keying #126# on the phone set that is connected to the
FXS port of the gateway. You will hear an IVR
announcing the current IPaddress of the WAN port.
When you select PPPoE mode, then fill out the fields of
PPPoE userID and PPPoE password for PPPoE
authentication.
When the gateway cannot get IP by DHCP or PPPoE,
original static IP address is accessible via the LAN port.
Representative Number: The representative number is
working as a SIP trunk for the selected FXS line (for all FXS
or FXO/FXS combination model) or FXO line (for all FXO
model).
Enable: Enable or disable the line to register or unregister to
SIP Proxy. By default, the setting is "Enable".
Account: Input the SIP Proxy registration account ID
Number: Input the phone number.
Password: Input the password of IP Proxy registration
account ID.
Display name: Specify the Display name of the phone
number
Step 3: Press the Apply button after you finish configuration.
Step 4: Go to Reboot , option and press the Reboot button. [ ]
Note: Please refer to user's manual for more details about
Note: SIP setting, Line setting, PSTN prefix routing, Dial
Note: plan, DM, etc..
WEEE Directive & Product Disposal
At the end its serviceable life ,this product should not be treated
as household or general waste. It should be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment, or returned to the supplier for disposal.
P/N: 2300-0559
5
7

Service Registration

Step 1: (SP5018A only)
Go to [ General Configuration > PABX Connection ] for PABX
connection mode. Select "Enable" for ISP/ITSP scenario that
forbids SIP calls to/from PSTN via the gateway. By default,
PABX mode is "Disable" for normal operation.
Step 2:
Go to [ General Configuration > SIP Setting ] and set the
server information here, if this VoIP gateway wants to use SIP
Proxy service to transfer the VoIP call.
Primary and Seconary proxy / P2P IP: Specify the data of
Enable/Disable, IP address, Port number, Domain Name,
Expire time, and MWI TTL.
Primary and Secondary Outbound proxy: Fill out the
Quick Installation Guide
IP Telephony Gateway
Model No.: SP5008A / SP5018A / SP5058A
Web: www.micronet.com.tw
6