To Avoid Breakage - Frigidaire FGGS3065PF Installation Instructions Manual

30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop.
The counter-top around the cut-out should be flat and leveled (see
1.
hatched area on illustration 1).
2. Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (see illustration 1) from the floor to the
top of the counter.
3. Level the range using the
leveling legs or leveling device
so that the height from the
floor to the underside of the
cooktop frame is greater than
the tallest cabinet measurement
by at least 1/16" (0,16 cm) (see
illustration 2).
4. Model equipped with leveling device: Remove and discard the two rear leveling legs,
they are only in place to solidify the unit during the transport.
5. Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center
of the cabinet cut-out.
6. Remove the protective channels on each side of cooktop (if equipped).
The metal flange under each side of the cooktop MUST be placed
7.
over the cabinet countertop for proper unit support. The cooktop
should NOT directly touch the countertop (see illustration 2) or
else it could cause damage to the cooktop
voiding the warranty. Level the unit if
needed.
8. After the installation,
MAKE SURE
that the unit is
supported by the
leveling legs NOT
by the cooktop.
(Models with Sealed Top Burners)
1 ½" Max.
(3,8 cm Max.)
Shave Raised Edge
to Clear Space for
a 31½" (80 cm)
Wide Cooktop.
5
H2
H1
H3
Illustration 1
To successfully
cooktop frame
(0,16 cm) taller
Illustration 2
H4
install the
range, the
initial level
height from
floor to
underside of
should be at
least 1/16"
than cabinet
sides as
measured in
step 2.