About This Guide; Install Driver And Utility - Rosewill RNX-G100 Quick Installation Manual

Wireless g usb adapter, wireless g pcmcia adapter, wireless g pci adapter

Hide thumbs Also See for RNX-G100:

RNX-G100 / RNX-G200 / RNX-G300(E)

1 . About This Guide

This Quick Installation Guide only provides you some basic instructions. For more detailed

information, please refer to the User Manual.

Before you begin, you must have at least the following:

A notebook /desktop pc with an available 32-bit Cardbus/PCI/USB slot

At least a 300MHz processor and 32MB of memory

Cardbus/PCI/USB controller properly installed and working in the computer

An 802.11g or 802.11b Access Point (for infrastructure Mode) or another 802.11g or 802.11b

wireless adapter (for Ad-Hoc; Peer-to-Peer networking mode.)

Windows Vista

The operating system will install all necessary driver files when a wireless adapter is plugged

into your computer. After approximately 1 minute, a message will appear at the lower

right-hand corner "Your new hardware is now installed and can be used." The hardware and

software installation is completed.

Windows 98SE/ME/2000/XP/VISTA

Insert the Driver and Utility CD-ROM into the CD-ROM driver.

The Wizard should run automatically, and Figure 2-1 should appear. If it doesn't, click the

Start button and choose Run. In the field that appears, enter C:\autorun.exe (if ''C'' is the

letter of your CD-ROM drive).

Figure 2-1

User Manual

Table of Contents

Rnx-g200 Rnx-g300(e)