Troubleshooting guide
age at N705 pin 2 (~3.1V, fig. 7.4).
Fig. 7.3 shows the component side of the circuit board.
•
If the input voltage is too low or missing, check the VDIG feed voltage (~3.2V) at C600 (fig. 7.4).
•
If VDIG is too low, measure the resistance from it to ground (>500 ohms).
•
If it's correct, replace N702 (class A, fig. 7.4).
•
If it's too low there's a short circuit in one of the circuits fed by this regulator. Send the phone to the
38
Fig. 7.3
Fig. 7.4
4/00021-2/FEA 209 544/6 C