Topcon Compu-Vision CV-5000 Instruction Manual page 7

Icon
To prevent the instrument from tipping over or falling and to avoid
injury, do not install the instrument on an uneven or unsteady sur-
face, including a slope.
To avoid electric shock, do not handle the plugs with wet fingers.
To avoid the damaged instrument or an injury caused by electric
shock, turn off the power switch and unplug the power cord before
cleaning the instrument.
When tilting the head for the near-point test, place the instrument
away from the patient to prevent him/her from being injured by col-
liding against it.
Do not tilt the head for the near-point test while the near-point rod
is inclined. The near-point rod may hit the instrument or desk to
damage the instrument.
Do not put your hand between the arm and the instrument. Your
hand may be pinched to cause injury.
To avoid injury due to contact, do not bring the face close to the
near-point rod.
This instrument has been tested (with 120V/230V) and found to
comply with IEC60601-1-2 Ed.3.0: 2007.
This instrument radiates radio frequency energy within standard
and may affect other devices in the vicinity.
If you have discovered that turning on/off the instrument affects
other devices, we recommend you change its position, keep a
proper distance from other devices, or plug it into a different outlet.
Please consult the dealer from whom you purchased the instru-
ment if you have any additional questions.
CAUTION
Prevention item Page
----
----
----
16
16, 18,
31
17
15, 18,
31
----
5