Connecting Rfd 900+ Telemetry - xCraft X2 Geo Operator's Manual

PREPARING THE X2 GEO FOR FLIGHT
STEP 2: Connect RFD 900+ Long Range Telemetry
(If not already installed you can download the QGroundControl program online at
qgroundcontrol.com/downloads). It is a free open-source program. As of the writing of this
manual version 3.1.3 is recommended.
Plug in RFD 900+ long range telemetry sensor into computer using the included
q
USB cable.
In QGroundControl Program:
w
i. Click
ii. Click
iii. Click "add" at the bottom.
iv. Under serial link settings – select serial port for vehicle.
v. Set baud rate to 57600.
STEP 3: Calibrate Vehicle. See next page.
CONNECTING THE RFD 900+ TELEMETRY
in upper left.
to connect to RFD 900+ long range telemetry.
www.
11