Troubleshooting; Specifications - Rosen 410X Owner's Manual

TROUBLESHOOTING

"Tinny" sound.
Check the "Downmix" setting in the SETUP menus and
ensure that it is set to "Stereo," not "LT/RT."
Picture "rolls."
Check that the TV Type setting is correct for the monitors
being used. (See "Changing the Video Output Mode".) PAL
video often "rolls" on NTSC monitors.
With a widescreen 16:9 monitor, I have black bars on the
top and bottom of my screen.
Change the TV Display mode to "Wide."

SPECIFICATIONS

Supply voltage:
12V DC Nominal, 11-16V operating voltage*
Temperature:
0 o to 50 o Celsius*
Current consumption:
Less than 3.0A
Video:
Television System: NTSC/PAL
Aspect ratio: 4:3, 16:9
TV encoder resolution: 10-bit DA converter
Video Signal-to-noise ratio: 65dB
Discs played:
DVD video discs—
5" (12 cm) single-sided, single and double-layer
3" (8 cm) single-sided, single and double-layer
Compact discs (CD-DA, VIDEO-CD, CD-R)—
5" (12 cm) disc
3" (8 cm) disc
Audio output level:
700mV RMS
Audio signal output characteristics:
Frequency response: 20 Hz - 20 kHz (CD audio/44.1kHz sampling
rate)
S/N ratio: 90 dB (JIS)
Crosstalk: -75dB
Dynamic range: Above 85dB
Distortion: 0.02% (1 kHz)
Digital audio output: SPDIF optical output (IEC 958)
* Note: Use of the 410X beyond the safe operating ranges listed can
cause temporary or permanent damage to the unit, and such damage
may not covered by the manufacturer's warranty.
27
410X