Rosen 410X Owner's Manual page 14

4. Installing the 410X
Installing into the DIN Sleeve
First, verify that the opening you will be mounting the 410X
into will accommodate the mounting sleeve.
Sleeve opening dimensions
7-3/16" (182 mm)
Hole
Note:
Some car models require special mounting kits for proper installation.
Consult your Rosen/necvox dealer for details.
1 Place the sleeve into the instrument panel opening. Ensure
a tight fit.
2 Bend the tabs of the sleeve inward as shown to lock the
sleeve into place.
3 Wire the power harness, make all connections to the 410X
(see "Wiring the 410X"), and plug in the power harness.
4 Gently insert the 410X into the mounting sleeve until it
locks into place with a 'click.'
5 Clip the trim ring into place.
14
410X
Instrument panel
Hole
Bend tabs to
lock sleeve into place
DIN sleeve clip
Trim ring
Rear fastening hole of vehicle,
or backstrap
Nut and washer
Rear mounting bolt
DIN mounting sleeve
Tabs