To D High Engineering Units; To D Display Mode; To D Sample Rate; To D Trim Enable - PowerTec Digimax Installation And Operation Instruction Manual

DIGIMAX ®
PARAMETER
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
#23 #23 A TO D HIGH ENGINEERING UNITS #23 A TO D HIGH ENGINEERING UNITS A TO D HIGH ENGINEERING UNITS A TO D HIGH ENGINEERING UNITS
#23 #23 A TO D HIGH ENGINEERING UNITS
The input at terminals 15 (-) and 17 (+) on TB2 may range from 0 to +10 VDC. This
parameter sets, in engineering units, what the effect of the 10 VDC level will be.
This parameter may be changed while the unit is running.
#24 #24 #24 A TO D DISPLAY MODE A TO D DISPLAY MODE A TO D DISPLAY MODE
#24 #24 A TO D DISPLAY MODE A TO D DISPLAY MODE
This parameter must be set to "0". It has not been implemented in software.
#25 #25 #25 #25 A TO D SAMPLE RATE #25 A TO D SAMPLE RATE A TO D SAMPLE RATE A TO D SAMPLE RATE A TO D SAMPLE RATE
This is the rate at which the voltage information on terminals 15 and 17 of TB2 is
updated. Valid values are 1 to 255. Each increment is 50 ms; a setting of 100 is 5 seconds.
#26 #26 A TO D TRIM ENABLE A TO D TRIM ENABLE
#26 #26 #26 A TO D TRIM ENABLE A TO D TRIM ENABLE A TO D TRIM ENABLE
When this parameter is set to 0, the analog input (TB2 terminals 15 and 17) is read
normally, as set up in parameters #22, #23, and #24. See page 7.
Page 20
DESCRIPTION
A to D low Engr Units
A to D high Engr Units
A to D Display mode
A to D Sample Rate
A to D Trim Enable

Communications Protocol

D to A Source
D to A low Engr Units
D to A high Engr Units
Maximum Ratio
Preset Input Mode
Reverse Input Mode
Up Input Mode
Down Input Mode
Installed Option Enable
Command Ratio Setpoint
Minimum Command Ratio
Debounce Value
AT SPEED Source
Comm Turn-Around Time
Table 1A: Additional parameters for the DIGIMAX
Parameter table (continued)
RANGE DEFAULT
0....999 0
0....999 100
0 0
1 to 255 1
0 to 1 0
0,2,3 0
0,1,2,3 0
0....99999 0
0....99999 10000
0....79999 79999
0,1,2 0
0,1,2,3 0
0,1 0
0,1 0
0,1 0
0....79999 0
0....79999 0
0....255 8
0 to 1 0
0 to 255 1
.
®
© copyright 1992-1996 by Powertec Industrial Motors
VALUE
SET TO "0"