Table of Contents
Advertisement
Quick Smart Features
Controlling the indoor units
14
individually
Use the Zone function to choose the indoor unit you
want to operate individually. For example, select
Zone 1 to control only the indoor unit 1.
Select one from
Zone 1 to Zone 4.
NOTE
You can select either one or all of Zone 1 to Zone 4.
The indoor unit numbers must be set by the
installer: the installer sets a number on each indoor
unit. To change the existing indoor unit numbers,
contact a service centre.
The current Zone function settings persist even if
you change the current mode or you turn off and
then turn on the remote control.
The zone selection you made using the remote
control is reset when the remote control batteries
are replaced.
12 English
Clean function
15
Use the Clean function to remove moisture from
the inside of the air conditioner for preventing
propagation of fungi, bacteria, etc.
NOTE
Depending on the condition of the indoor unit, the
Clean operation stops after running for 30 seconds
to 20 minutes.
When the Clean function is set, the Timer LED on
the indoor unit blinks 3 times for 3 seconds (OFF
ON
OFF
ON
OFF
to the previous state). When the Clean function is
cancelled, the Timer LED on the indoor unit blinks
once for 1 second (OFF
previous state).
You cannot use the Clean function after starting the
Timed Off or good'sleep function.
If you turn on the air conditioner and then turn it off
within 20 seconds, the Clean function does not operate.
When the air conditioner is turned off, the Clean
function operates immediately. When it is turned on,
the Clean function operates after it is stopped.
Once the Clean function is started, it automatically
continues to operate until it is cancelled.
Clearing the filter-cleaning
16
reminder
Use the Filter Reset function to reset the filter-
cleaning reminder after cleaning or replacing the filter.
Select
Filter Reset.
Select
Clean.
ON
OFF
returns
ON
OFF
returns to the
Hide quick links:
Advertisement
Table of Contents
