Supplying Ac Power To The Device - Philips DreamStation BiPAP autoSV User Manual

DreamStation BiPAP autoSV User Manual
2.3

Supplying AC power to the device

Complete the following steps to operate the device using AC power:
1. Plug the socket end of the AC power cord (included) into the power supply (also included).
2. Plug the pronged end of the AC power cord into an electrical outlet that is not controlled by a wall switch.
3. Plug the power supply cord's connector into the power inlet on the side of the device.
4. Verify that the plug at the side of the device, at the power supply, and at the electrical outlet are fully
inserted. This will help to ensure that a secure, reliable electrical connection has been made.
Note
If the Incorrect Power Supply icon appears on the screen, please repeat step 4.
Important
To remove AC power, disconnect the power supply cord from the electrical outlet.
Warning
Periodically inspect electrical cords and cables for damage or signs of wear. Discontinue use and
replace if damaged.
Caution
Do not use extension cords with this device.
Device setup 15