Table of Contents
Advertisement
ST0
Reports the general settings. Typical output is:
TM 1, TP 20.00ms
Where:
TM
Internal trigger: 0 = off, 1 = on
TP
Internal trigger period
Simulate an Input Trigger
TR1
Simulates a trigger pulse. If the channel is in pulse mode it will pulse.
Enable Ethernet Messages
GTm
m
= 0 to disable Ethernet messages
= 1 to enable Ethernet messages
When Ethernet messages are enabled, any error reports are sent to the most recent UDP or
TCP address from which a command has been received.
Messages are of the form:
Evt1,e
Where
v
Clear any Errors
GR
If Ethernet messages are not enabled, the last event or error number can be read by this
command. If there was a lighting error, the VTR1 will resume operation.
The reply will be in the same form as the GT command above. If there are no outstanding
events or errors, then only the prompt ">" is returned.
Set/Clear the Webpage Password
EY
EY asc1, asc2, asc3, asc4, asc5, asc6
This command sets the password required to access the webpages. If EY is entered on its
own then the password is cleared. There are six optional parameters, which are decimal
ASCII values for a password from one to six letters. A value of 65 is 'A', 66 is 'B', etc to
90 is 'Z'.
event value:
32 to 47
Lighting error code
19
Advertisement
Table of Contents
