Webpage Configuration; General Setup Page - GARDASOFT VTR1 User Manual

9

Webpage Configuration

This applies to the Ethernet version only. The VTR1 has a webserver inside, so that it can be
configured from a standard web browser, such as Internet Explorer.
The IP address of the VTR1 must be known (see section 7 on Ethernet Address. Open a web
browser window and type the IP address (for example 192.168.1.71) of the VTR1 into the URL
box at the top. The main page of the VTR1 webserver should be shown.
9.1 Main Page
The main page shows general information about the VTR1. Links are provided to the
configuration pages.
9.2

General Setup Page

The General Configuration page allows the webpage protection password to be set or cleared and
the internal trigger to be set up. Also any Ethernet command from section 10 can be entered.
"Test Mode" referred to on this page is the internal trigger timer.
9.3 Light Configuration Page
This page allows the parameters for the light output to be set up. Press the Submit button to
update the VTR1 and save the changes to non-volatile memory.
Some measured values are displayed on this page.
9.4 Trigger Output Configuration Page
This page allows the parameters for the trigger output to be set up. Press the Submit button to
update the VTR1 and save the changes to non-volatile memory.
15