Before Your First Fire; Filling The Hopper; User Interface; Startup - Quadra-Fire TREKKER-CSB Owner's Manual

E. Before Your First Fire
1. First, make sure your appliance has been properly
installed and that all safety requirements have been met.
Pay particular attention to the fire protection and venting.
2. Double check that the firebox is empty and the fire pot
floor is fully closed.
3. Close and latch the door.
F. Filling the Hopper
Open the hopper lid by lifting the handle. Fill the hopper
with fuel. Close the hopper lid. The unit will not feed with
the hopper lid open and the fire will go out.
G. User Interface
The appliance comes with a user interface and Bluetooth
Figure 9.1
key, both need to connected for the appliance to operate.
Reference user interface manual supplied for installation
and operation instructions. Figure 9.1
H. Startup
The unit will go into the ignition sequence followed by a
start up sequence (the user interface will read STARTUP).
The ignition sequence involves the exhaust blower and
igniter turning on, and the feed motor running in two stages.
The first stage involves the feed motor running continu ously
for about a minute to start loading pellets into the fire pot.
In the second stage, the feed motor will begin cycling on
and off.
When the pellets are warming - on the verge of igniting - it
is not uncommon for the firebox to fill with smoke.
Once ignition happens, the smoke should quickly disap-
pear. During this stage, as well as any part during the burn
process, the front door should not be opened.
This startup cycle continues until the unit senses ignition by
a rise in the exhaust temperature or the unit times out. Fol-
lowing the ignition cycle the unit continues to feed pellets to
build up the fire.
After warming up, the convection blower will begin to blow
warm air into the room. As the appliance increases heat
the blower will increase its output.
April 18, 2018
HEATING
65
72
I. Fire pot Purge
Purpose: To help remove debris from the fire pot and help
the unit burn as efficient as possible.
The frequency of the purge cycle is once every 30 minutes
while the unit is burning. During the fire pot purge, the feed
is reduced to the lowest setting and the exhaust blower
ramps up to a very high setting. The purge cycle lasts 99
seconds.
The purge cycle does not replace daily cleaning.
J. Shutdown
To shut the appliance down, turn the user interface to OFF
from the main menu. During the shutdown process, the
user interface will read shutdown. Once shutdown is estab-
lished the user interface will read standby.
Unlike the fire pot purge, during shutdown existing fuel in
the fire pot will continue to burn without the feed motor run-
ning; but, the exhaust and convection blowers will remain
on until the exhaust has cooled.
HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING
AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN
BURNS.
7080-166B
CAUTION
TREKKER
9