Roland TD-6V Owner's Manual page 70

Chapter 2 Making the Pad and Trigger Settings (SETUP/TRIG)
3. Press [ENTER
fig.02-002ai.e
4. Strike the pad you wish to set.
The setting screen for the struck pad appears.
You can also make your selection by holding down [Shift]
and pressing [ ] or [
This setting applies to both the head and rim.
5. Find the trigger type for the pad you are using
from the following chart.
Pad Trigger Type
PD-8 PD-8
PD-6 PD Type
PD-7
PD-9
RP-2 PD-80R
PD-80
PD-80R
PD-85
PD-100
PD-120 PD-120
PD-105 PD-125
PD-125
KD-8 KD-8
• Use the "RT-7K," "RT-5S," or "RT-3T"setting when you
use acoustic drums to sound the TD-6V. For details refer
to "Using the TD-6V with Acoustic Triggers" (p. 75).
There may be no improvement of conditions when non-
Roland pads are used, even after changing the trigger
parameter settings. For fullest expression in performance,
we recommend the exclusive use of Roland pads.
70
].
].
Pad Trigger Type
KD-7 KD Type
KD-80
KD-85
KD-120
CY-8 CY-8
CY-6 CY Type
CY-12H
CY-12R/C
CY-14C
CY-15R
RT-7K RT-7K
RT-5S RT-5S
RT-3T RT-3T
Rim Edge Rim
6. Press [+] or [-] to make the setting.
When rim is selected, "Rim" becomes the set value, and
no changes can be made to the setting. Select head, then
make the settings for the head. However, using AUX and
TOM4 requires selecting the rim settings for TOM2 and
TOM3.
fig.02-003ai.e
7. When you finish making settings, press [KIT] or
[SONG] to end the procedure.
TrigTyp (Trigger Type):
PD-8, PD Type, PD-80R, PD-120, PD-125, KD-8,
KD Type, CY-8, CY Type, RT-7K, RT-5S, RT-3T,
RIM
Connecting Two Pads to Trigger Input
5/6 (TOM2/AUX) and 7/8 (TOM3/4)
1. With a single pad connected to each of the
trigger inputs, carry out Steps 1-3 as described
above.
2. Select a pad by striking the pad's rim.
If using Trigger Input 5/6 (TOM2/AUX), select the
TOM2 rim; to use Trigger Input 7/8 (TOM3/4), select the
TOM3 rim.
You can also make your selection by holding down [Shift]
and pressing [ ] or [
3. Press [-] to change the trigger input number
and name to "AUX:H06" or "TOM4:H08" and
enable AUX or TOM4.
Value
].