Midi Channel Settings For A Part; Midi Messages Stop Function For Specific Parts In Gm (General Midi) Mode - Roland TD-6V Owner's Manual

Chapter 7 Making the MIDI Settings (SETUP/MIDI, BULK DUMP)
ON:
The drum kits are switched when Program Change messages
are received from an external MIDI device.
MIDI Channel Settings for a
Part (MIDI PART)
For each part, you can specify the channel on which the TD-6V
will receive and transmit MIDI messages.
At a setting of "1" through "16," MIDI messages will be
transmitted and received on that channel. When set to "OFF,"
MIDI messages for that part are not transmitted.
Drum kit parts and percussion parts can be overlaid and set to
"CH 10." Make the "CH10Priorty (Channel 10 Priority)"
setting to determine whether the drum kit part instrument or
percussion part instrument is to be sounded when MIDI
messages are received (SETUP/MIDI COMMON/
CH10Priorty; p. 98).
In GM mode (p. 99), the part's channel is predetermined, and
thus cannot be changed.
1. While holding down [SHIFT], press [EDIT
(SETUP)].
[EDIT] lights.
2. Press [
] to select "MIDI PART."
fig.SETUP-MIDIPRT_50
When "GM Mode" is set to "ON," "GM PART" is
displayed, and you cannot make the setting. Make the
setting after first setting "GM Mode" to "OFF" (SETUP/
MIDI COMMON/GM Mode; p. 99).
3. Press [ENTER
4. Press [
] or [
fig.07-022ai.e
5. Press [+] or [-] to make the setting.
6. When you finish making settings, press [KIT] or
[SONG] to end the procedure.
102
].
] to select the part to be set.
Select Part
fig.07-023ai.e
Part CH (Part Tx Rx Channel): CH 1–CH16, OFF
MIDI Messages Stop Function
for Specific Parts in GM
(General MIDI) Mode (GM PART)
In GM mode, you can make the setting that determines
whether or not MIDI messages are to be received for each
individual part.
When set to "OFF," that part's MIDI messages are not
received.
1. While holding down [SHIFT], press [EDIT
(SETUP)].
[EDIT] lights.
2. Press [
] to select "GM PART."
fig.SETUP-GMPRT_50 (SETUP-MIDI PART)
When "GM Mode" is set to "OFF," "MIDI PART" is displayed,
and you cannot make the setting.
Make the setting after first setting "GM Mode" to "ON"
(SETUP/MIDI COMMON/GM Mode; p. 99).
3. Press [ENTER
4. Press [
] or [
fig.07-024ai.e
5. Press [+] or [-] to make the setting.
fig.07-025ai.e
6. When you finish making settings, press [KIT] to
end the procedure.
Part Rx Sw (Part Rx Switch): OFF, ON
Value
].
] to select the part to be set.
Select Part
Value