Viessmann VITODENS 200-W Installation And Service Instructions Manual page 32

Type b2hb, b2kb, 1.8 to 35 kw wall mounted gas condensing boiler with vitotronic 200, weather-compensated natural gas and lpg version
Table of Contents

Advertisement

Commissioning, inspection, maintenance
Commissioning the system with the commissioning...
Menu point
"Control unit"
"Building type"
"Filling and venting"
"Gas type"
"Energy cockpit"
"Flue system"
(not Vitodens 3xx)
Calling up the commissioning assistant at a later
point
If you need to continue commissioning later, the com-
missioning assistant can be reactivated at any time.
Tap the following buttons:
1. "Menu" or "
"
Extended commissioning assistant
32
Settings and explanations
"Weather-compensated"
Delivered condition
"Constant"
The control unit can be switched to constant operation (not Vitodens 3xx) if the
system configuration makes this necessary. Not all the described settings are
available in this operating mode.
Note
With each change, all the settings revert to the factory settings.
"Detached house"
One shared holiday program and time program for DHW heating
"Apartment building"
Holiday program and time program for DHW heating can be set separately
See chapters "Filling the heating system" and "Venting the heating system".
Only for operation with LPG: See chapter "Gas type conversion".
To convert the gas type, enter password "9".
"ON"
The Energy cockpit with various scanning options is displayed.
"OFF"
The Energy cockpit is not displayed.
"Single connection"
Only one boiler is connected to the flue system.
"Multiple connections"
Several boilers are connected to the flue system.
2. "Service"
3. Enter the password "viservice".
4. "Commissioning"
1. Call up the extended commissioning assistant with
"Yes" or "
".
A safety instruction is shown on the display.
Note
The extended commissioning assistant can be
skipped with "No" or " ".
2. After successfully reviewing the safety information,
tap "Yes" or "
" to confirm. Detection of the con-
nected sensors and system components connec-
ted via KM-BUS begins.
This process may take some time.
3. After detecting the devices, tap "Next" or "
A list of detected system components (device list)
appears on the display.
(cont.)
".

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents