Quantum Scalar i6000 Quick Start Manual page 8

aa Insert the Domain (red) iKey and press Enter.
READING DOMAIN...
Enter PED PIN:
ab Enter the PIN for the Domain (red) iKey and press Enter.
READING DOMAIN...
Are you duplicating this keyset? (Y/N)
ac Press No
LOGIN SECRET VALUE...
MxCT-c7F9-HHX5-YtH3
Please write it down. Press Enter.
ad Write down the password displayed on the PED.
The KeySecure CLI displays the following message:
Do you want to set the HSM password now? (y/n): y
The KeySecure CLI displays the following message:
Luna PED operation required for crypto user login on HSM - use User or
Partition Owner (black) PED key.
The PED displays the following text:
USER LOGIN...
Insert a USER / Partition Owner PED Key. Press ENTER.
ae Insert the User/Partition (black) iKey and press Enter.
USER LOGIN...
Enter PED PIN.
af Enter the PIN for the User/Partition Owner (black) iKey and press Enter.
The KeySecure CLI displays the following message:
Crypto user successful logged into the HSM
18 Configure the SSKM network interface. Alternatively, you can configure the SSKM network interface
later, using the CLI or the management console. For information about configuring the SSKM network
interface after installing the KeySecure, see Chapter 3, "SSKM Interface Configuration".
Do you want to configure the SSKM Network Interface now (y/n): y
IP Address (in same subnet as IP of physical interface): 192.168.15.125
Netmask: 255.255.255.0
You have entered the following configuration:
IP address: 192.168.15.125
Subnet mask: 255.255.255.0
Is this correct? (y/n): y
Network Templates generated OK
IP address 192.168.15.125 scheduled for assignment to SSKM
Q S 6000 & S
UANTUM CALAR I
N K S Q
AFE ET EY ECURE UICK
S G
TART UIDE
11