Probox user manual
7.5 Monitor Controller function
This option is only available when it is enabled in the config menu.
7.5.1 Monitor Section
Use the three buttons "2 TRACK A 2 TRACK B or 2 TRACK C" to select your Input for the
Control Room. This input signal can be switched to mono via the "MONO" button or be
dimmed via the "DIM" button.
It can be sent to either the main output by pressing the "MAIN" button or to the Nearfield
output by pressing "NEAR FIELD" . If you press a selected Speakers button again, the led
will flush and the Output will be muted.
7.5.2 Cue Section
Use the Master Vpot to control the signal on the STUDIO Out jacks. The Signal on the Studio
Out will be the same as on the Speakers (vaild for Logic and Mackie Protocol).
For HUI use the Main Fader to control this audio Output, as this Vpot is used as scroll wheel
for the HUI display section.
On the Phones/Cue Mix 1 /2 area you can select the Inputs Aux9/10,
Aux 11/12 or the Signal on your Main/Nearfield Speakers by pressing
"AUX 9-10" , "AUX 11-12" or "CONTROL ROOM" . Control the
volume of the Phones via the Vpot.
Page 53 of 63