Setting Up For Logic - Probox d8b User Manual

Probox user manual

6.5 Setting up for Logic

In logic the controller is auto detected and installed. It can happen that the order is wrong, e.g. channel 1-8 in
Logic is 17-24 on the d8b.In this case bring the MCU and XTs into the right order (see screen shots). The
screenshots are done with Logic X but are valid for all Logic versions. MCU must be right, the XTs in the middle
and left, all three have to be on one group to ensure 24 channels in parallel. The MCU on the right side must
have MCUPort4, the XT in the middle must be MCUPort3 and the left one must have MCUPort2.
Group
Page 25 of 63