Viewing Information About; (System Version Info Screens) - Roland GW-8 Owner's Manual

System Settings
Rx
Rx Sync
OFF, ON
Rx Pitch
OFF, ON
Bend
Rx
Refer to "MIDI Parameters" (p. 44).
Modula- OFF, ON
tion
Rx
Program
OFF, ON
Change
SYSTEM METRONOME
Parameter Value
Metronome
OFF, ON
Switch*
ALWAYS,
Metronome
REC,
Refer to "Using the Metronome" (p.
Mode
PLAY
23).
LOW,
Metronome
MEDIUM,
Level
HIGH
SYSTEM LOCK
Parameter
Value
Style OFF, ON
Tone OFF, ON
Refer to "Preserving Certain
Style
Settings Even When You Switch
OFF, ON
Tempo
Performances ([LOCK])" (p. 16).
Trans-
OFF, ON
pose
MASTER EQ settings (p. 37) are stored in System settings.
Settings cannot be stored for the parameters marked by "*" in
the table. When the power is turned on, these parameter will
always return to the same value (the default value).
System settings that are not stored
In addition to the parameters marked by "*" in the above
table, the following settings cannot be stored.
• BALANCE button setting (p. 24)
• Recording setting (p. 28)
Rec Mode/Count In/Punch In/Out setting/Input Quantize
• D Beam controller on/off (p. 34)
• LOCK button on/off (p. 16)
• ANALOG MODIFY SELECT button setting (p. 37)
• External input Center Cancel (p. 17)
• MINUS ONE/CENTER CANCEL button on/off (p. 30, p. 32)
48
Explanation
Explanation
Viewing Information about GW-8

(System Version Info Screens)

Here's how to view information about the GW-8 such as its
software version.
1. Press [MENU].
2. Use [ ] [ ] to select "Version" then press [ENTER].
3. Use [ ] [ ] to select a page.
You can view information about the imported Special
Tones as well as the version of software used by the
GW-8.
4. Press [EXIT] to return to the Main screen.