Distortion → Chorus; Distortion → Flanger; Distortion → Delay; Enhancer → Chorus - Roland GW-8 Owner's Manual

DISTORTION → CHORUS
69:
The parameters are essentially the same as in "66: OVERDRIVE
CHORUS," with the exception of the following two.
Overdrive Drive → Distortion Drive, Overdrive Pan
fig.MFX-69
L in
Distortion
R in
DISTORTION → FLANGER
70:
The parameters are essentially the same as in "67: OVERDRIVE
FLANGER," with the exception of the following two.
Overdrive Drive → Distortion Drive, Overdrive Pan
fig.MFX-70
L in
Distortion
R in
DISTORTION → DELAY
71:
The parameters are essentially the same as in "68: OVERDRIVE
DELAY," with the exception of the following two.
Overdrive Drive → Distortion Drive, Overdrive Pan
fig.MFX-71
L in
Distortion
R in
ENHANCER → CHORUS
72:
fig.MFX-72
L in
Enhancer
Mix
R in Enhancer
Mix
Parameter Value
Enhancer Sens 0–127
Enhancer Mix 0–127
Chorus Pre Delay 0.0–100.0 ms
→ Distortion Pan
L out
Balance D
Balance W
Chorus
Balance W
R out
Balance D
→ Distortion Pan
Balance D
L out
Feedback
Balance W
Flanger
Balance W
R out
Balance D
→ Distortion Pan
L out
Balance D
Balance W
Delay
Balance W
Feedback
R out
Balance D
L out
Balance D
Balance W
Chorus
Balance W
R out
Balance D
Description
Sensitivity of the enhancer
Level of the overtones generated
by the enhancer
Adjusts the delay time from the di-
rect sound until the chorus sound is
heard.
Parameter
Chorus Rate
→
Chorus Depth
Chorus Balance
Level
ENHANCER → FLANGER
73:
fig.MFX-73
L in
Enhancer
→
R in Enhancer
Parameter
Enhancer Sens
Enhancer Mix
Flanger Pre Delay
Flanger Rate
Flanger Depth
Flanger Feedback
Flanger Balance
→
Level
Value Description
0.05–10.00 Hz,
Frequency of modulation
note
0–127 Depth of modulation
Adjusts the volume balance between
D100:0W– the sound that is sent through the cho-
D0:100W rus (W) and the sound that is not sent
through the chorus (D).
0–127 Output Level
Balance D
Mix Feedback
Flanger
Balance D
Mix
Value Description
0–127 Sensitivity of the enhancer
Level of the overtones generated
0–127
by the enhancer
Adjusts the delay time from when
0.0–100.0 ms the direct sound begins until the
flanger sound is heard.
0.05–10.00 Hz,
Frequency of modulation
note
0–127 Depth of modulation
Adjusts the proportion of the
flanger sound that is fed back into
-98– +98%
the effect. Negative (-) settings will
invert the phase.
Adjusts the volume balance between
D100:0W– the sound that is sent through the
D0:100W flanger (W) and the sound that is not
sent through the flanger (D).
0–127 Output Level
Effects List
L out
Balance W
Balance W
R out
79