3D Delay; Time Ctrl Delay; Long Time Ctrl Dly - Roland GW-8 Owner's Manual

Effects List
52:

3D DELAY

This applies a 3D effect to the delay sound. The delay sound will be
positioned 90 degrees left and 90 degrees right.
fig.MFX-52
L
3D Delay L
3D Delay C
Feedback
3D Delay R
R
Parameter Value
Delay Left
Delay Right 0–2600 ms, note
Delay Center
Center
-98– +98%
Feedback
HF Damp 200–8000 Hz, BYPASS
Left Level
Right Level 0–127
Center Level
Output Mode SPEAKER, PHONES
Low Gain -15– +15 dB
High Gain -15– +15 dB
Balance D100:0W–D0:100W
Level 0–127
53:

TIME CTRL DELAY

A stereo delay in which the delay time can be varied smoothly.
fig.MFX-53
L in
Time Ctrl Delay
Feedback
Feedback
Time Ctrl Delay
R in
Parameter Value
Delay Time
0–1300 ms, note
Acceleration 0–15
Feedback -98– +98%
74
2-Band
L out
EQ
Level
2-Band
R out
EQ
Description
Adjusts the delay time from the
direct sound until the delay
sound is heard.
Adjusts the proportion of the de-
lay sound that is fed back into the
effect. Negative (-) settings will
invert the phase.
Adjusts the frequency above
which sound fed back to the ef-
fect will be cut. If you do not want
to cut the high frequencies, set
this parameter to BYPASS.
Output level of the delay sound
Adjusts the method that will be
used to hear the sound that is out-
put to the OUTPUT jacks. The opti-
mal 3D effect will be achieved if
you select SPEAKER when using
speakers, or PHONES when using
headphones.
Gain of the low range
Gain of the high range
Volume balance between the direct
sound (D) and the effect sound (W)
Output Level
2-Band EQ L out
Pan L
Pan R
2-Band EQ R out
Description
Adjusts the time until the delay is
heard.
Adjusts the speed which the Delay Time
changes from the current setting to a
specified new setting.
The rate of change for the Delay Time
directly affects the rate of pitch change.
Adjusts the amount of the delay
that's fed back into the effect. Neg-
ative (-) settings invert the phase.
Parameter Value
200–8000 Hz,
HF Damp
BYPASS
Low Gain
-15– +15 dB
High Gain -15– +15 dB
D100:0W–
Balance
D0:100W
Level 0–127

LONG TIME CTRL DLY

54:
(LONG TIME CONTROL DELAY)
A delay in which the delay time can be varied smoothly, and allowing
an extended delay to be produced.
fig.MFX-54
L in
Time Control Delay
Feedback
R in
Parameter Value
0–2600 ms,
Delay Time
note
Acceleration
0–15
Feedback -98– +98%
200–8000 Hz,
HF Damp
BYPASS
Pan L64–63R
Low Gain -15– +15 dB
High Gain
-15– +15 dB
D100:0W–
Balance
D0:100W
Level 0–127
Description
Adjusts the frequency above which
sound fed back to the effect is fil-
tered out. If you do not want to filter
out any high frequencies, set this
parameter to BYPASS.
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct
sound (D) and the delay sound (W)
Output level
2-Band
EQ
Balance D
Balance W
Balance W
2-Band
EQ
Balance D
Description
Adjusts the time until the delay is heard.
Adjusts the speed which the Delay Time
changes from the current setting to a speci-
fied new setting.
The rate of change for the Delay Time di-
rectly affects the rate of pitch change.
Adjusts the amount of the delay that's fed
back into the effect. Negative (-) settings in-
vert the phase.
Adjusts the frequency above which sound
fed back to the effect is filtered out. If you do
not want to filter out any high frequencies,
set this parameter to BYPASS.
Stereo location of the delay
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct sound
(D) and the delay sound (W)
Output level
L out
R out