Power Supply Status - Radionics D2112 Diagnostic Manual

Point Status
The Point Status function displays the electrical
state of all points. The state of each point is
shown with its corresponding light.
1. Press ( 5 ).
The lights update every second.
Light
OFF
WINK
ON
2. Press ( CLEAR ) to exit this test.
Relays
The Relays function can activate either of the
two external relay outputs.
1. Press ( 6 ) to enter the Relays function.
2. Press and hold ( 1 ) to activate relay 1.
...light 1 will be on while you hold the key.
3. Press and hold ( 2 ) to activate relay 2.
...light 2 will be on while you hold the key.
4. Press ( CLEAR ) to exit this test.

Power Supply Status

The Power Supply Status function performs four
different tests on the power supply and battery.
The results of the test are displayed as a bar
graph using lights 1 through 8.
For example: If the current consumption is at
500mA, lights 4, 5, 6, 7 and 8 are on.
When a test indicates an overload condition,
the bar graph flashes.
Point State
Normal
Open
Short
5
6
7
3