Mission Management - ResortLOCK LockState RL 4000 User Manual

6. Mission Management

Mission management allows you to perform several different tasks with your lock, like issue Lock
Operation Schedules, check settings, change lock time, etc. Each tab within the Mission
Management window is described below.
Set Parameter Key
This mission will set lock parameters, such as LED "Blink", lock passing time, adjust lock time,
and enable "Daylight Saving".
Set Time Key
This step uses the DS1904 or DS1994 key to set the real time of the lock
Tip: Other than DS1904/1994 real time key, the DS1977 program key can also set the time of the
lock. But program key will cause time delay since programming the mission key and programming
the lock will take time. We recommend use DS 1904/1994 real time key if the programming
process takes more than 3 minutes.
Get Information Key
The Get Information mission is a useful tool to retrieve the existing lock information, such as: Key
list, lock time, Time Setting and lock ID, Batteries voltage, etc.
Lockout Key
Set Lockout key to selected locks, the lock will be put in Lockout mode (lock or unlock) and will
forbid all the assigned keys/codes to operate the lock. Apply the Lockout key (any Lockout Key)
again to release the Lockout Mode. There are two Lockout Modes:
Lockout and Open: Apply to the door, lock will stay unlock and lockout all the users.
Lockout and Close: Apply to the door, lock will stay lock and lockout all the users.
Multiple locks can be selected in one key. Use DS1977 for this type of key.
24