Using The Cmc Gui To Set The Ip Address - Dell FC SAN User Manual

2
Modify the FC SAN Module IP address
2. At the command prompt, type connect switch-x where x is the bay where the FC SAN Module is
3. At the login prompt, enter the default user name as "admin" and password as "password".
4. Use the appropriate CLI commands to change the IP address of the selected FC SAN module.

Using the CMC GUI to set the IP address

To change the IP address, use the following steps:
1. Open the CMC application's Setup tab.
2. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate
3. To enable DHCP, select DHCP Enabled and click Apply.
FIGURE 4
NOTE
Refer to the application for additional detail.
16
installed. For example, switch-x can be:
•
Switch-3 for FC SAN Module installed in bay B1.
•
Switch-4 for FC SAN Module installed in bay B2.
•
Switch-5 for FC SAN Module installed in bay C1.
•
Switch-6 for FC SAN Module installed in bay C2.
Refer to your Blade Enclosure CLI documentation.
and click Apply.
CMC Setup tab
Dell 8/4Gbps FC SAN Module Hardware User's Manual
53-1001964-01