Spectracom VersaSync Quick Reference Manual page 9

CHAPTER •
1 VersaSync Evaluation Kit Quick Reference Guide Rev. 5
i.
Navigate to MANAGEMENT > Network Setup .
ii.
In the Ports panel on the right, click the GEAR button next to ETH0 or
ETH1: The Edit Ethernet Port Settings panel will open.
Note:
Enable DHCPv4
completing all IP configuration settings.
e.
Click Submit, and start a new Web UI session by entering the new IP
address into your browser, and logging into the Web UI again.
f.
You have now established a network connection with VersaSync. Continue
with other configurations e.g., NTP settings, references, outputs, etc. See
manuals.spectracom.com
the user manual:
If you have not disabled DHCP yet, uncheck
, but DO NOT click
.
Submit until after
5