Registering The Repeater; Star Setup - Yealink RT30 User Manual

Star setup:

Up to 6 repeater can be registered to one base station to extend available
reception range for all registered handsets. All repeaters must be installed
within the base station coverage area (up to 300m in unobstructed outdoor
areas and up to 50m inside buildings), as shown in the figure below.

Registering the Repeater

Registration: You can register the repeater to a base station to extend
available reception range.
Cascade Registration: If you want to cascade setup 2 repeaters, you need
to register the repeaters first and then perform cascade registration on the
second repeater.
Modify the ID: After registering to the base station, every repeater has their
own ID, they use ID to distinguish each other. If the IDs of two repeaters are
duplicated, you need to modify the ID manually.
De-registration: Registration cannot be performed if the repeater is already
registered to one base station. In this case, de-register the repeater before
attempting registration.
Registration
If you want to register more than one repeater, we recommend that you put
the base station and repeaters together and register the repeaters one by
one, to prevent the ID duplication.
1. Plug the repeater into a AC outlet.
POWER LED is green and DECT LED is flashing red.
www.yealink.com
RT30
50m/300m
RT30
W60B
RT30
RT30
RT30
RT30
4