Advertisement
1.
Hold the handset and stand near the base.
2.
Make a call, and carry the handset away from
the base.
3.
Make a note where you start to hear noise on
the line, which indicates
the signal is getting
weaker.
The optimum location for the repeater is as far from
the base as possible while still maintaining a good
signal, or just inside the location where the noise
became noticeable.
Here are a few tips for placing repeaters:
DECT Repeater RT20U User Guide
Choose a raised position for both the base station and repeater
wherever possible.
When positioning the repeater, avoid obstacles that can interfere
with radio transmission such as thick wall and metal structures that
may be in the coverage area between the base station and repeater.
Avoid interference from other electrical appliances such as micro-
wave ovens, Hi-Fi equipment, computers etc.
Keep a minimum of 10 meters between multiple repeaters to avoid
coverage area overlapping.
Registering the Repeater
Registration cannot be performed if the repeater is already registered to
one base station. In this case, de-register the repeater before attempting
registration. For more information, refer to "De-registration".
Registration
1.
Plug the repeater into a AC outlet.
Power LED is green and DECT LED is slowly flashing red.
2.
Enable the repeater mode on the handset at the path: Settings->
System Settings->Repeater Mode.
3.
Set base station in registration mode (Long press paging key on
the base
station till the first LED flashes).
If base station is found, DECT LED will fast flash green.
When DECT LED is on, registration to base station is successful
(green: good DECT link).
Note: You cannot set the base station in registration mode, if there are 5 handsets
registered on the base station.
Relay Connection
Incoming call:
1. Place a call to the handset in repeater
zone.The Relay LED on repeater is green.
www.yealink.com
6
Advertisement
