Cascade Registration; Auto Cascade Registration; Manually Cascade Registration; Modify The Id - Yealink RT30 User Manual

2. Set the handset in RT30 repeater mode at the path: Settings->System
Settings->Repeater Mode.
3. Set base station in registration mode (Long press paging key on the base
station till the first LED flashes).
If base station is found, DECT LED will flash yellow.
When DECT LED is green/yellow, registration to base station is successful.

Cascade Registration

Up to 2 repeaters can be registered to the base station in a cascade setup.
Before performing the cascade registration, you should register the 2
repeaters first.
When performing cascade registration, we recommend you that put the
repeaters together and make the repeaters stay away from the base station.
The repeater supports automatic or manually cascade registration.

Auto Cascade Registration

1. Long press the program key on second repeater about 3 seconds.
The second repeater starts searching for the first repeater, POWER LED is
yellow and DECT LED is flashing green.
When POWER LED is green and DECT LED is green/yellow, auto cascade
registration is successful.

Manually Cascade Registration

1. On first repeater:
a. Check the ID: Press the program key. And the ID is indicated by the
number of times the RELAY LED flashes green.
2. On second repeater:
a. Long press the program key about 3 seconds.
POWER LED is yellow and DECT LED is flashing green.
b. Enter the first repeater's ID by pressing the program key. The ID will
increase by one each time the program key is pressed.
POWER LED is yellow and DECT LED is green. And the number of times
the RELAY LED flashes indicates the entered ID.
c. Press the program key about 3 seconds to confirm the ID.
The second repeater starts searching for the first repeater, POWER LED
is green and DECT LED is flashing yellow.
When POWER LED is green and DECT LED is green/yellow, manually cascade
registration is successful.

Modify the ID

1. Press the program key to check the ID.
2. Long press the program key about 3 seconds to enter the ID modifying
mode.
POWER LED is red and DECT LED is green/yellow.
3. Enter the first repeater's ID by pressing the program key. The ID will
increase by one each time the program key is pressed.
The number of times the RELAY LED flashes indicates the entered ID.
4. Long press the program key about 3 seconds to confirm the ID.
The repeater will re-register to the base station/repeater.
5
DECT Repeater RT30 User Guide