Nd Mad-Enabled Irf Configuration Example - HPE FlexFabric 5700 Series Configuration Manual

<DeviceE> system-view
[DeviceE] stp global enable
[DeviceC] stp region-configuration
[DeviceC-mst-region] region-name arpmad
[DeviceC-mst-region] instance 1 vlan 3
[DeviceC-mst-region] active region-configuration
[DeviceC-mst-region] quit
# Create VLAN 3, and assign ports Ten-GigabitEthernet 1/0/1, Ten-GigabitEthernet 1/0/2,
Ten-GigabitEthernet 1/0/3, and Ten-GigabitEthernet 1/0/4 to VLAN 3 for forwarding ARP MAD
packets.
[DeviceE] vlan 3
[DeviceE-vlan3] port ten-gigabitethernet 1/0/1 to ten-gigabitethernet 1/0/4
[DeviceE-vlan3] quit

ND MAD-enabled IRF configuration example

Network requirements
As shown in
•
Configure ND MAD in the IRF fabric and use the links connected to Device E for transmitting
ND MAD packets.
•
To prevent loops, run the spanning tree feature between Device E and the IRF fabric.
Figure 18 Network diagram
XGE1/0/1~XGE1/0/4
XGE1/0/2
Device A
XGE1/0/45
XGE1/0/46
(IRF-port1/1)
XGE3/0/45
XGE3/0/46
(IRF-port3/2)
Device C
Configuration procedure
1. Configure Device A:
Figure 18, set up a four-chassis IRF fabric in the IPv6 enterprise network.
Device E
IRF
XGE1/0/47 XGE2/0/47
XGE1/0/48 XGE2/0/48
(IRF-port1/2) (IRF-port2/1)
XGE3/0/2 XGE4/0/1
XGE3/0/47 XGE4/0/47
XGE3/0/48 XGE4/0/48
(IRF-port3/1) (IRF-port4/2)
IP network
XGE2/0/1
Device B
XGE2/0/45
XGE2/0/46
(IRF-port2/2)
XGE4/0/45
XGE4/0/46
(IRF-port4/1)
Device D
46