Reliant Rebel 700 1967 Workshop Manual page 92

1 Arm rest
2 Retainer
3 Trim panel
4 Trim panel
5 Prop shaft tunnel carpet
6 Parcel shelf carpet
7 RH bulkhead carpet
8 LH bulkhead carpet
9 RH door well carpet
10 LH door well carpet
11 RH floor well carpet
12 LH floor well carpet
13 Upper bulkhead carpet
14 Lower bulkhead carpet
15 RH toe box carpet
16 LH toe box carpet
17 Heel board carpet
18 Front RH floor carpet
19 Front LH floor carpet
Fascia
Removal (Figures 5 & 6)
1. Disconnect the battery.
2. Remove the air cleaner.
3. Disconnect the heater control valve cable.
4. Disconnect the choke cable at the carburettor.
5.
Disconnect the demister air hoses from the heater unit.
6. Prise off the steering wheel centre motif and remove the
9/16" UNF nut and plain washer.
7. Mark the position of the steering wheel hub relative to the
column, then remove the steering wheel.
8. Remove the two screws and washers and detach the multi-
switch cover complete with retaining clamp from the
steering column.
20 Rear LH floor carpet
21 Rear LH floor carpet
22 Stud fastener
23 Rivet
24 Pronged fastener
25 Clinch plate
26 Headlining – saloon
27 Headlining – estate
28 Finisher
29 Rear floor cover
30 Back squab cover
31 Access cover plate
32 Gasket
33 Screw
34 Nut
35 Seat belt hook
36 Listing rod
37 Listing rod
38 Listing rod
Page 92
39 Listing rod
40 Front trim fillet
41 Centre trim fillet
42 Rear trim fillet
43 Rear view mirror
44 Screw
45 Mirror fixing insert
46 Sun visor
47 Listing rod bracket
48 Rivet
49 Rear casing panel
50 Gear lever grommet
51 Retaining ring
52 Screw
53 Nut
54 Boot carpet
55 Grommet
9. Unscrew the two multi-switch securing screws and remove
clamp, spacer, multi-switch and indicator cancel bush from
the steering column.
10. Disconnect multi-switch wiring and remove the assembly.
11. Remove the RH access panel from the interior of the glove
compartment and disconnect the screen washer tubes from
the operating plunger.
12. Unscrew the bezel nuts securing the ignition, lights and
wiper switches and remove the wavy washers. Push the
switches through to the rear of the fascia with their
electrical connections intact.
13. Unscrew fixing screw, plain washer, lock washer and nut
locates under the RH side of the fascia and remove the
indicator flasher unit.
14. Disconnect the speedometer drive cable from the rear of
the instrument.