Robitronic Overloader 2 Instruction Manual page 24

Cycle charge & discharge
ENTER /
START
Current
cycle
MODE /
CANCEL
How to start a cycle process
To start a cycle process you have to choose a profile
with an activated cycle function. This selection can
be done in the charge or discharge mode.
ENTER /
- The button START within the charge or discharge
mode will start the cycle charge & discharge dialog..
ENTER /
- START Confirms and starts the cycle according to
the adjustment with charging resp. discharging
the battery.
MODE /
- exits the cycle start.
CANCEL
During a cycle
You can see the number of the currently running cycle in
the right hand upper corner of the screen.
- Every button with the exception of
used as usual, just like known from the regular
charge or discharge mode.
How to stop a running cycle
MODE /
- The button CANCEL has to be pressed to stop a running
cycle. To avoid an accidental stop of a running cycle,
an additional dialog follows.
ENTER /
- Pressing START is a confirmation and stops the running
cycle process.
MODE /
- Pressing ends the dialog and keeps the cycle
CANCEL
process running.
Between active cycle steps
the system is waiting according to the adjustments until the
battery has reached the adjusted cooling-off temperature or
until the adjusted time delay has run out. Status information
about the delay period is provided via popups.
ENTER /
- The START button overrules the adjusted cooling-off time
or temperature and starts immediately the next cycle step.
- PLEASE NOTE: that it might be possible, that after too
short of an cooling-off time the following charging could
be stopped way too early due to the high temperature of
the battery.
24
MODE /
CANCEL can be